Welcome to another Emergency Water Well post. If you are looking for help learning how to drill a well then you are in the right place. This is the complete water well drilling process. We know that it can be a complicated process and that is why we want you to pay attention to each of the steps in this guide.
There are many reasons why you should consider installing a water well in your home. Among them is the saving of the water bill. We know that a well is an important investment, that is why you must first be clear about how to install it and the benefits it can offer you.
Water wells are important for a series of advantages and benefits that their drilling implies. Obviously it is advantageous to have a source of water available, cheap and under our absolute control
Water is a vital element for human beings, plants and animals, having a reliable and autonomous way of a strategic resource like this is extremely important. Therefore, it is recommended that you have a water well as a backup.
A water well consists of a hole drilled from the surface, with the top lined with liner. The casing prevents the collapse of the well walls with which the liner is cemented. This prevents contaminants from entering the water supply. The liner creates space for a pumping system and for the tubing that drives the water from the pump to the surface.
The quality of the materials used in well drilling is an important factor. The casing must meet certain specifications, as inferior quality pipes are not strong enough to withstand conduction without potential damage to the joints.
You might also like to read: Low Water Pressure Well Solution
The casing should also have a drive shoe attached to the bottom to prevent damage while driving and to make a good seal with the formation. Below the casing, at the bottom of the well, is the inlet through which the water enters the well. The intake can be an open hole in the solid rock or it can be screened and filled with gravel, depending on geological conditions. This will preserve the well from sandblasting.
Once the well is completed, it is unloaded or pumped to develop the well and determine performance. Possible development methods include compressed air (blown), bilge, air injection, discharge, or pump. The amount of water (performance test) is usually measured during development. The minimum test time is one hour.
After proper disinfection, the well is capped to provide sanitary protection until hooked into the customer’s system. Well caps require an air vent. The purpose of ventilation is to equalize the air pressure between the inside of the housing and the atmosphere, and to release gases that are lighter than air.
If such gases are present and the well is enclosed in a building or confined space, the air outlet must always extend to the outside atmosphere.
The ventilation pipe must be protected and screened to prevent the entry of foreign material such as insects.If the piercing produces poor quality water, it can be sealed. One method is to install an additional shell or liner inside the original shell and snap it into place.
If the water quality remains unsatisfactory, or if construction defects cannot be remedied, the well must be abandoned and completely sealed to prevent cross contamination.
If you are looking for help, you will be interested to know that the first thing you should do is obtain permission from the corresponding sanitary agencies before starting construction.
The corresponding bodies that control matters relating to water establish standards that must be followed for the construction of wells and among the regulations is the fact that they must be drilled by companies legally constituted and authorized by the corresponding authorities.
In addition to choosing a suitable company for the construction of your house, there are other points that you must decide, among which is the location, this decision cannot be taken lightly. You must bear in mind that there should be no possible sources of contamination near your location.
That is why Emergency Water Well offers you a different alternative. Our kits are made so that anyone can install them without the need for advanced knowledge. If you want to avoid headaches then call us and ask about our DIY water well kits. Our team is here to help you make the right decisions.
Want more information on water well drilling rig? Click the link below to contact us.